SiREM staff contribute to the research article “Evaluation of a Rapid Biosensor Tool for Measuring PAH Availability in Petroleum-Impacted Sediment” that was published in Environmental Advances 3 (2021) 100032.

Michael Healey & Steve Sande (SiREM) contributed to the research lead by Jason Conder, Ph.D. (Geosyntec Consultants) by performing the ex situ SP3™ passive sampling experiments. Their coauthors were Mehregan Jalalizadeh (Exponent), Hong Luo & Amanda Bess (Chevron Energy) and Michael Unger (Virginia Institute of Marie Science).

Michael Healey, (Treatability and SP3™ Services Coordinator) and Steve Sande (Laboratory Technician) based in Guelph, ON were involved in the development and work in SiREM’s porewater passive sampling service area.

Environmental Advances is an international and fully Open Access journal supporting the rapid publication of peer-reviewed original research articles, short communications and review papers dealing with all aspects of the environmental sciences. Their vision is to ensure maximum accessibility and appeal to a diverse readership in the environmental sciences and beyond.

Elsevier’s mission is to help researchers and healthcare professionals advance science and improve health outcomes for the benefit of society.

Published Abstract

Decades of research have shown that the concentration of freely dissolved PAH (Cfree) in sediment correlates with PAH bioavailability and toxicity to aquatic organisms. Passive sampling techniques and models have been used for measuring and predicting Cfree, respectively, but these techniques require weeks for analytical chemical measurements and data evaluation. This study evaluated the performance of a portable, field-deployable antibody-based PAH biosensor method that can provide measurements of PAH Cfree within a matter of minutes using a small volume of mechanically-extracted sediment porewater. Four sediments with a wide range of PAHs (ΣPAH 2.4 to 307 mg/kg) derived from petroleum, creosote, and mixed urban sources, were analyzed via three methods: 1) bulk chemistry analysis; 2) ex situ sediment passive sampling; and 3) biosensor analysis of mechanically-extracted sediment porewater. Mean ΣPAH Cfree determined by the biosensor for the four sediments (3.1 to 55 µg/L) were within a factor of 1.1 (on average) compared to values determined by the passive samplers (2.0 to 52 µg/L). All mean values differed by a factor of 3 or less. The biosensor was also useful in identifying sediments that are likely to be non-toxic to benthic invertebrates. In two of the four sediments, biosensor results of 20 and 55 µg/L exceeded a potential risk-based screening level of 10 µg/L, indicating toxicity could not be ruled out. PAH Toxic Units (ΣTU) measured in these two sediments using the passive sampler Cfree results were also greater than the ΣTU threshold of 1 (6.7 and 5.8, respectively), confirming the conclusions reached with the biosensor. In contrast, the other two sediments were identified as non-toxic by both the biosensor (3.1 and 4.3 µg/L) and the passive sampler (ΣTUs of 0.34 and 0.039). These results indicate that the biosensor is a promising tool for rapid screening of sediments potentially-impacted with PAHs.

More Information

Learn more about the article: https://www.sciencedirect.com/science/article/pii/S266676572100003X
Learn more about Environmental Advances: https://www.sciencedirect.com/journal/Environmental-Advances For consultation regarding SiREM’s Passive Sampling Product and Services contact Brent Pautler at bpautler@siremlab.com or visit: https://www.siremlab.com/sediment-pore-water-sampler/
Learn more about Michael: https://www.linkedin.com/in/michael-healey-596b53160/
Learn more about Steve: https://www.linkedin.com/in/steven-sande-a4264752/